Chapter 5: Performing Library Operations
Releasing Magazines
Quantum Scalar i40 and Scalar i80 User’s Guide
115
Note:
If you want to remove more than one magazine, such as when
bulk loading tape cartridges, release and remove all the
magazines you want to remove before you close any of them.
Otherwise, if you remove and replace them one at a time, you
must wait for the robot to complete inventory on the one
being replaced before it can release another one.
Caution:
If the library is turned
ON
, always release the magazines via
the user interface. It is easier and will not result in a
diagnostic ticket (see
About Diagnostic Tickets
on
page 244). Additionally, the library makes sure nothing is
physically blocking the magazine that could cause damage
to library components before allowing you to release it.
Releasing Magazines
via the User Interface
Use this method when the library is turned
ON
.
Operator Panel
1
Select
Actions > Magazine
.
2
Select a magazine and press
Release
.
3
Wait until the screen displays the “magazine is now unlocked”
message (see
Figure 27
), then pull outward on the magazine bezel
handle to slide the magazine out as far as you wish, or remove it
completely. Once you slide the magazine back into the slot all the
way, it locks again automatically
If you do not open the magazine within 30 seconds, it locks and you
receive a diagnostic ticket.
Figure 27 Magazine Unlocked
Message
Summary of Contents for Scalar i40
