Quantum Scalar i40, User Manual

Page: 69 / 328

Chapter 4: Configuring the Library
Configuring Network Settings
Quantum Scalar i40 and Scalar i80 User’s Guide 43
Note: Make sure that the library is connected to the network before
modifying network settings. If the Ethernet cable is not
installed properly, you cannot configure the network settings.
Install one end of the Ethernet cable in the left-most Ethernet
port of the system control board (SCB) located on the back of
the library. Make sure the other end of the Ethernet cable is
installed in the appropriate LAN port on your LAN.
You can configure the following network settings. Some settings are
only available on the Web client; others are only available on the
operator panel, as described below.
Library Host Name
The host name is the network name you want to assign to the library.
The library name is limited to 12 lowercase alphanumeric characters and
dashes (-).
You can view, but not modify, the library host name on the operator
panel. To modify the library host name, you must use the Web client.
Web Client
1 Select Setup > Network Management > Network .
2 Type a name in the Library Name field, and click Apply .
DHCP
DHCP is enabled by default. When DHCP is enabled, the library obtains
an IP address automatically. If DHCP is disabled, you must manually
enter an IP address, default gateway, and subnet mask/net prefix. You
can enable/disable DHCP from the operator panel or Web client.
Operator Panel
Select Setup > Network Configuration .
Web Client
Select Setup > Network Management > Network .