Quantum Scalar i40, User Manual

Page: 240 / 328

Chapter 8: Installing, Removing, and Replacing Components
Removing and Installing a Filler Plate
214 Quantum Scalar i40 and Scalar i80 User’s Guide
Removing and
Installing a Power
Supply Filler Plate
The power supply filler plate is used only on the Scalar
®
i80 when only
one power supply is present.
Removing a power supply filler plate
1 Unscrew the two captive thumbscrews.
2 Pull out on the thumbscrews so the filler plate is at a slight angle
and the bottom of the filler plate is still attached in the slot.
3 Lift the filler plate up to disengage the catch at the bottom and pull
the filler plate out of the slot.
Installing a power supply filler plate:
• On the Scalar i80, if you are using only one power supply, you
should install the power supply in the upper slot, and cover the
lower slot with a filler plate (see Figure 52 on page 215).
1 Hold the filler plate with the thumbscrews at the top.
2 Insert the bottom edge of the filler plate into the slot, engaging the
bottom edge of the filler plate into the bottom of the slot.
3 Pivot the filler plate up to fit securely in the hole.
4 Tighten the thumbscrews.