Quantum Scalar i40, User Manual

Page: 225 / 328

Chapter 8: Installing, Removing, and Replacing Components
Removing and Replacing the Front Bezel
Quantum Scalar i40 and Scalar i80 User’s Guide 199
4 Slide the library one-to-two inches forward out of the rack or over the
edge of the table or desk in order to access
the two bottom bezel
screws
.
WARNING: Only slide the library out far enough out to access the
two screws on the bottom of the library. The library is
not secured in the rack or on the desk. Pulling it out
too far could cause the library to slide out of the rack
or off the desk.
Caution: Ensure there is enough slack in the power cords and
cables connected in the rear of the library so that you
do not dislodge them when you slide the library
forward.
Caution: Do not tip the library or tilt it on its side.
5 Make sure all the magazines are pulled out a few inches (or
removed) to allow you to remove and install the bezel without
damaging it.
6 Remove and set aside the two screws securing the bezel to the
bottom of the chassis (see Figure 46 on page 200).
7 Remove and set aside the two screws securing the bezel to the top
of the chassis (see Figure 47 on page 201).
Installed in a desktop kit Release the desktop cover by removing two screws at
rear of the desktop cover, then slide the desktop cover
toward the back of the library two or three inches.
Installed very low in a rack so
that you cannot access the
bottom bezel screws unless you
remove the library from the
rack
Remove the library from the rack (see Removing the
Library From a Rack on page 188).
If your library is... Follow these steps...