8-4
8
1. Receiver
Receives the signal sent from the
remote control.
This lamp is lit when the unit is
operating.
When an error occurs, one of the
lamps flashes. When a display
lamp is blinking, refer to " Before
Requesting Service ".
2. Emergency
operation button
Display lamps
When the heater is working, the
lamp lights at the following times.
When the thermostat has operated
during defrosting at the time of the
startup.
The lamp flashes when an error
occurs.
5. Standby lamp
3. Operating lamp
This lamp is lit when the timer is set.
4. Timer lamp
6. Filter lamp
This lamp is for notifying you when
the filter needs to be cleaned.
Use in the
Normal
position. It does
not operate in the
Stop All
position.
Remote control, main / remote
control, secondary, switch
In normal use this should be on
remote control, main. It is also
possible to use both in conjunction
with a wired remote control
(sold separately). (Consult with the
dealer where the product was
purchased about making the
settings.)
Test/On switch
This is used during service. It is not
for normal use.
Test Run/On switch
This is used during service. It is not
for normal use.
7. Swing button
8. Normal/Stop
All switch
9. Address switch
Differentiate between incoming and
outgoing signals.
If a heat pump model is being used, it will beep twice and the operating lamp will light up on the display; if the timer and standby
lamps blink alternately, a conflict between the heating and cooling exists, so the unit cannot operate in the desired mode.
(On models that do not have an Auto function, even if Auto is selected, it works in the same way.)
RECEIVER
CZ-RWSU2
1
2
3
4
5
6
7
8
9
CZ-RWSC2
2
1
3 4 5
CZ-RWST2
When the local operation is disabled by such as the centralized control, and if the Start, Stop, Mode or Temperature setting
buttons are pressed, the unit will beep five times and the change will not be made.
Display
CZ-RWSL2
Indoor Unit (CZ-RWSK2)
3 4 5
1
2
7
8
9
Operation Panel
3
4
5
2
NOTE
2
3
4
5
1
CZ-RWSY2
2
3
4
5
1
Sec8.indd 4
2012/02/28 16:14:00
1
5
4
3
2
CZ-RWST3
SM830211-07̲PAC-i.indb 4
SM830211-07̲PAC-i.indb 4
2013/09/17 23:03:31
2013/09/17 23:03:31
Summary of Contents for U-100PEY1E5
