59
Getting Started
Setting the Hard Disk Lock
When the [Hard Disk Lock] is set to [Enabled], it is impossible to read/write data from/to the hard disk
when the hard disk is inserted in a different computer.
Note that this Hard Disk Lock does not guarantee complete protection of data.
1
Start up the Setup Utility. (
page 57)
If the password has been set, enter the Supervisor Password, and press
.
When the Supervisor Password has not been set, set the Supervisor Password. (
below)
2
Select [Security] using or .
To set the supervisor password:
1
Select [Set Supervisor Password] using
or
, and press
.
2
Enter your password in [Create New Password] and press
.
3
Enter your password again in [Confirm New Password] and press
.
3
Select [Hard Disk Lock] using or , and press
.
4
Select [Enabled] using or , and press
.
5
At the confirmation message, press
.
6
Press
, and then select [Yes] and press
.
When starting up the computer, if the message [Hard disk access is prohibited by “Hard Disk Lock”]
appears, run the Setup Utility, and change the settings to match the details when [Hard Disk Lock] was
set.
DFQW5600ZA̲BasicManual̲CF-S10.indb 59
DFQW5600ZA̲BasicManual̲CF-S10.indb 59
2011/11/15 14:08:26
2011/11/15 14:08:26
