Oki BV1250, Installation Manual, Page: 255 / 344

Oki BV1250 Installation Guide LOGICAL INSTALLATION
Revision 1.0 Page 245 of 334
5.9.2 Configure a Gatekeeper Unit
Using the Maintenance Console Software to configure network Gatekeepers
is very similar to the methods used to configure a Gateway but the number
of configuration parameters is considerably fewer.
The Maintenance Console Software display uses a set of tabbed folders to
organize the configuration process. Each of these folders contains fields in
which configuration data are entered.
The data to be entered should have already been identified and recorded on
a Unit Setup Worksheet for the unit being configured. Field definitions and
parameter descriptions are provided in Section 3.2.3.
Much of the data recorded during the unit configuration process is critical
to the proper operation of the equipment and care must be taken to avoid
errors.
As discussed earlier, when a unit is selected and the Edit Data command is
used, the Maintenance Console Software asks if a saved file is to be edited
or if the file in the unit should be downloaded.
If the saved file is to be edited, the Maintenance Console Software displays
a dialog box in which the file to be edited can be selected. See section 5.7 to
review this process.
Once the file to be edited has been selected, the Maintenance Console
Software displays the configuration folders for the Gatekeeper unit.
Each of these folders is discussed below.
Only Oki Gatekeepers can be configured using the MCS. See the
manufacturer’s documentation for other Gatekeepers.
When an H.323 Gatekeeper address is configured within the BV1250
network, it takes precedence over all other network management
facilities. All external DNS and BV1250 internal DNS settings will be
ignored.