Oki BV1250, Installation Manual

Page: 92 / 344

E&M WORKSHEETS Oki BV1250 Installation Guide
Page 82 of 334 Revision 1.0
Trunk Data
Use the Trunk Data section of the worksheet to record information needed
to configure each of the active ports on the BV1250-E&M unit.
If a port on the BV1250-E&M unit is not used, this should be
indicated and, in the Maintenance Console Software, the Clear
button should be used to remove all default settings. Failure to
logically disable an unused port can result in calls being lost
because they are erroneously routed to an inactive port.
Port No. (TRK)
The Port # field indicates the port to be configured, e.g. ports 1 to 4.
To the right of each port are fields for the port’s setup parameters.
Provide information for each of the unit’s active ports.
Trunk Group (TRK)
Use the Trunk Group Field to define from 1 to 4 Trunk Groups to be
associated with a BV1250-E&M/E&M-OD unit: Trunk Group 1,
Trunk Group 2, Trunk Group 3, and Trunk Group 4.
A trunk is a connection between one E&M IVG port and a PBX E&M
card. A Trunk Group consists of a collection of trunks on a BV1250
unit. At least one group must be defined and up to four Trunk Groups
(ports 1 to 4) can be defined for a BV1250 unit.
B S 1 2 0 0 E & M / E & M - O D
P B X
1 trunk group
2 trunk groups
2 trunk groups
Figure 3-18: Trunk Groups
In the sample, the Trunk Group parameter for all ports is recorded as
the default, 1 (e.g. All ports are members of the same Trunk Group.)