Oki BV1250, Installation Manual, Page: 208 / 344

LOGICAL INSTALLATION Oki BV1250 Installation Guide
Page 198 of 334 Revision 1.0
5.9 Configure Units
Once a Gateway or Gatekeeper unit has been created using the Unit Information
Setup Wizard, the Maintenance Console Software has created a configuration file
(OFDD.VHO) for the unit. This file must now be configured with data that will
allow the unit to operate properly in the network environment in which it is
installed.
The Maintenance Console Software permits all configuration file data to be
entered and edited while off-line. Once the configuration data for one or more
units has been entered into the MCS, each unit’s configuration file can be saved to
a hard disk and /or uploaded to unit’s using the network interface.
58
In the procedures discussed in this chapter, the completed configuration files will
be uploaded to the units using a LAN connection.
See Section 4.7 Section for additional information about the LAN connection.
To begin the configuration process, highlight the unit to be configured by clicking
on the unit’s icon and then select the Maintenance Console Software’s Edit Data
item from the Unit menu.
Hints:
Click the Toolbar Edit Configuration
icon.
Place the mouse cursor over the unit to
be configured, click the right mouse
button, and use the pop-up menu’s
Edit
Data item.
58
Additional methods for uploading and downloading configuration files are discussed in Appendix I:
of this document.