NOVA electronics Inc.
MCX514 -
14
－
14
－
<Further Note>
*1
Parameter that is used in S-curve acceleration / deceleration driving.
*2
Pulse range that can be set for the driving that outputs specified pulses.
In continuous driving, pulses are output up to infinity.
*3
Automatic deceleration stop performs decelerating stop automatically by calculating the deceleration start point based on
specified drive pulses. Manual deceleration stop performs decelerating stop by setting the deceleration start point from
the high order. This IC can perform automatic deceleration stop except for non-symmetrical S-curve acceleration /
deceleration.
*4
After the start of driving, output pulse number can be changed for the same direction in only relative position driving.
The drive speed cannot be changed during continuous interpolation driving.
*5
Logical position counter counts output pulses and real position counter counts encoder input pulses.
*6
While driving, split pulses are output at specified intervals in synchronization with driving pulses.
*7
1 set of synchronous actions is configured with one specified activation factor and one specified action.
*8
Input pins for external signals share the general purpose input / output pins.
*9
When the function is not used, it can be used as general purpose input.
*10
Drive status output signal pins share the general purpose input / output pins.
*11
Bit pattern interpolation is 4Mpps or less, helical interpolation is 2Mpps or less, continuous interpolation is 4Mpps and
multichip interpolation is 4Mpps or less.
