Notifier UniNet 2000, Installation, Operation, And Administration Manual

Page: 22 / 200

22 The Workstation Installation/Operation Manual Version 2 Document 51540 Rev. B1 4/8/02
The address of the workstation supervisor is set using the DIP switch settings shown in Figure 1-8 (S2). If the board
came pre-installed from the factory, the address will already be set. If the supervisor is being installed in the field, be
sure to use the currently defined default setting unless directed by a Notifier technician to do otherwise.
The default setting is 700H.
NOTE: Use only wire for power
limited systems. Power limited
wire runs use type FPLR, FPLP,
FPL or equivalent cabling per
NEC 760.
NOTE: Switches S5 & S6 are
not used.
S1 S2 S3 S4 Address
ON ON ON ON 700H - 706H
OFF ON ON ON 710H - 716H
ON OFF ON ON 720H - 726H
OFF OFF ON ON 730H - 736H
ON ON OFF ON 740H - 746H
OFF ON OFF ON 750H - 756H
ON OFF OFF ON 760H - 766H
OFF OFF OFF ON 770H - 776H
ON ON ON OFF 780H - 786H
OFF ON ON OFF 790H - 796H
ON OFF ON OFF 7A0H - 7A6H
OFF OFF ON OFF 7B0H - 7B6H
ON ON OFF OFF 7C0H - 7C6H
OFF ON OFF OFF 7D0H - 7D6H
ON OFF OFF OFF 7E0H - 7E6H
OFF OFF OFF OFF 7F0H - 7F6H
Figure 1-8: Workstation Supervisor DIP Switch Settings