Notifier UniNet 2000, Installation, Operation, And Administration Manual

Page: 145 / 200

145
The Workstation Installation/Operation Manual Version 2 Document 51540 Rev. B1 4/8/02
Figure 4-19: Time Code Configuration
4.10.2 Time Codes
To add a time code, enter a name, start and stop time, and the days of the week to which the time code is as-
signed. It is also possible to specify if the time code applies on holidays by checking or unchecking the box
labeled "Hol" in the Time Codes Form.
Each time code must contain a start time, stop time, and at least one day upon which it applies (although it is
possible to set a time code for holidays only). Times are based on a twenty four hour clock and minutes are
inclusive. Therefore, to set a time code to end at midnight the code must be defined as 23:59.
Time codes can have a wide range of applications which include (but certainly are not limited to), specifying times
a door is unlocked or locked, activating a point or output on a set schedule, setting times that an individual can
access certain locations, etc. The application of time codes and their related data depends entirely on the applica-
tion or device that implements them.
On 16C48M and 48M NIONs, the input state may also be defined. Options include:
• Not Configured - for unused inputs.
• 2 State Normally Open - normally open input reporting active and normal.
• 2 State Normally Closed - normally closed input reporting active and normal.
• 4 State Normally Open - normally open input reporting active, normal, short and open.
• 4 State Normally Closed - normally closed input reporting active, normal, short and open.
NOTE: In order to utilize any four state settings, the input circuit must be wired with the appropriate
supervision devices. For more information, refer to section 1.6: NION-16C48M/48M in the
Network Installation Manual.
To configure a large block of inputs to the same state option on a NION, use the Multiple State Configuration
box on the I/O Configuration form. Simply enter the range of input points in the From and To fields, select the
desired state option in the Configure As combo box then click the Set State button to finish.