Notifier UniNet 2000, Installation, Operation, And Administration Manual

Page: 131 / 200

131
The Workstation Installation/Operation Manual Version 2 Document 51540 Rev. B1 4/8/02
The Burle CCTV NION Plug-In controls the Pan/Tilt/Zoom functions
available via the Burle CCTV NION and allows full software control of
zoom, focus, and iris open/close.
Camera and Monitor frames - combo boxes which allow the user to
select which camera/monitor to access. Switching a camera to a
monitor is accomplished by selecting a camera number and monitor
number and clicking on
Switch
.
Joystick - The Joystick controls the pan and tilt capabilities of a Burle
CCTV camera. To use the joystick, click on the joystick and move the
mouse to push it in the desired direction. As long as the mouse button is
depressed, the joystick will move towards the cursor, even if the cursor
moves past the boundaries of the control. The camera will pan faster the
farther the joystick is moved away from the center. Releasing the mouse
button causes the joystick to re-center, stopping the camera's movement.
Zoom/Focus/Iris Controls - The Zoom/Focus/Iris controls allow
access to these functions of the Burle CCTV camera. Click and hold on
the "+" or "-" buttons to change the zoom, focus, or iris.
Seq - To implement a sequence programmed via the Burle monitor, select
Seq
, and enter the desired sequence
number. Select
Start
,
Stop
,
Prev
,
Next
, and
Hold
as desired.
Preset - After adjusting ptz to the desired view, select Configure , Set Preset Location , and enter a preset
number (1-99) and Apply . To access the preset, click on Preset , enter the preset number, and click on GOTO .
4.6: Burle Plug-In Application
4.6.1 The Burle Plug-In Interface
This plug-in application (Burle.exe and .cfg) controls the Burle CCTV NION through the interface shown below:
Joystick
Zoom/
Focus/Iris
Controls
Configure
pull-down
m e n u
Text Box
Figure 4-5: Burle CCTV NION Plug-In Interface
4.6
Figure 4-6: Sequencing and
Preset Location