Mitsubishi L26CPU-BT, User Manual

Page: 162 / 450

8 - 56 8 - 56
8 FUNCTIONS
(3) Method for initializing only a specified station (specification of
remote device station to be initialized)
When a running remote device station is replaced due to a failure, initial
processing that has been done for all stations conventionally can be performed
for the replaced remote device station by specifying it. Remote device stations
other than the specified station continue their operations.
The following shows an example in which remote device station number 3 is
specified to be initialized.
1) First of all, execute the initial settings for all remote device stations
(station numbers 1, 3, 5, 7).
2) When a failure occurs on remote device station number 3 during
operation, replace the failed remote device station.
3) Specify the replaced station number 3 as a remote device station to be
initialized. Then, perform the initial processing.
During initial processing of station number 3, control of the other
stations (station numbers 1, 5, 7) is continued.
(a) How to specify the remote device station to be initialized
Set the station to be initialized in the "specification of remote device station
to be initialized (SW0014 to SW0017)" in the link special register.
To set this, turn ON the bit corresponding to the specified station number
within SW0014 to SW0017 (only the bit of the head station number).
When all bits are OFF, initial processing is performed on all stations that are
set in the "Remote Device Station Initial Setting" in the Network Parameter
setting.
b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
16 15 14 13 12 11 10 9 8 7 6 5 4 3 1 2
32 31 30 29 27 28 26 25 24 23 22 21 20 19 17 18
47 48 46 44 45 43 42 40 41 39 37 38 36 35 34 33
64 63 62 61 59 60 58 56 57 55 54 52 50 53 51 49
b15
Numbers 1 to 64 in the above table indicate the station numbers.
SW0014
SW0015
SW0016
SW0017