Mitsubishi Electric MELSEC-L LD75D, User Manual

Page: 175 / 818

173
CHAPTER 5 DATA USED FOR POSITIONING CONTROL
5
5.
4 List
of
B
loc
k St
art
Dat
a
Remark
To perform an high-level positioning control using block start data, set a number between 7000 and 7004 to the "[Cd.3]
Positioning start No." and use the "[Cd.4] Positioning starting point No." to specify a point number between 1 and 50, a
position counted from the beginning of the block.
The number between 7000 and 7004 specified here is called the "block No.".
With the LD75, up to 50 "block start data" points and up to 10 "condition data" items can be assigned to each "block No.".
*2 Setting cannot be made when the "Pre-reading start function" is used. If any of Nos.7000 to 7004 is set and the Pre-
reading start function is performed, the error "Outside start No. range" (error code: 543) will occur. (For details, refer to

Page 598, Section 12.7.7.)
Block No.
*2 Axis Block start data Condition Buffer memory GX Works2
7000
Axis 1
Start block 0
Condition data (1 to 10)
Supports the
settings
Supports the
settings
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
Axis 4 Condition data (1 to 10)
7001
Axis 1
Start block 1
Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
Axis 4 Condition data (1 to 10)
7002
Axis 1
Start block 2
Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
Axis 4 Condition data (1 to 10)
7003
Axis 1
Start block 3
Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
Axis 4 Condition data (1 to 10)
7004
Axis 1
Start block 4
Condition data (1 to 10)
Axis 2 Condition data (1 to 10)
Axis 3 Condition data (1 to 10)
Axis 4 Condition data (1 to 10)