Mitsubishi Electric MELSEC-L LD75D, User Manual

Page: 92 / 818

90
(2) Connecting and disconnecting cables
(a) When a bar solderless terminal is used
• Connection
• Disconnection
(b) When a bar solderless terminal is not used
• Connection
• Disconnection
(3) Operating the open/close lever
The following shows how to operate the open/close lever of the differential driver common terminal.
For operation, use a commercially available small flathead screwdriver.
When a bar solderless terminal is not used, strip the cable jacket 8 to 11mm. If the length is too short, a secure connection
may not be obtained.
A flathead screwdriver is not required. Directly insert a cable with a bar solderless terminal into the slot so
that the crimp side faces to the external device connector (faces to the left when viewed from the insertion
direction).
Open the slot using a flathead screwdriver and disconnect the cable from the slot. When two cables are
connected, disconnect the cable of the upper slot first.
Open the slot using a flathead screwdriver and insert a cable to the slot. When two cables are to be used,
connect a cable to the lower slot first.
Open the slot using a flathead screwdriver and disconnect the cable from the slot. When two cables are
connected, disconnect the cable of the upper slot first.
Lever
Insertion slot
Lever
Push the driver onto the hollow
of the lever (orange) straight.
The lever goes down and the
insertion slot opens.
Insertion slot
Flathead
screwdriver
Flathead
screwdriver