Mitsubishi Electric MELSEC-L LD75D, User Manual

Page: 168 / 818

166
• The table below lists the control systems that require the setting of the arc address and the associated
setting ranges when "[Pr.1] Unit setting" is "inch". (With any control system excluded from the table below,
the arc address does not need to be set.)
*4 Set an integer because the program cannot handle fractions. (The value will be converted properly within the system.)
*5 Note that the maximum radius that circular interpolation control is possible is 536870912, although the setting value can
be input within the range shown in the above table, as an arc address.
[Da.2] setting value Value set with GX Works2 (inch)
Value set with program
*4
(

10
-5
inch)
ABS circular sub: 0DH
ABS circular right: 0FH
ABS circular left: 10H
■ Set the address
-21474.83648 to 21474.83647
■ Set the address
-2147483648 to 2147483647
INC circular sub: 0EH
INC circular right: 11H
INC circular left: 12H
■
Set the movement amount
-21474.83648 to 21474.83647
*5
■
Set the movement amount
-2147483648 to 2147483647
*5
ABS helical sub: 20H
ABS helical right: 22H
ABS helical left: 23H
■ Set the address
-21474.83648 to 21474.83647
■ Set the address
-2147483648 to 2147483647
INC helical sub: 21H
INC helical right: 24H
INC helical left: 25H
■ Set the movement amount
-21474.83648 to 21474.83647
*5
■ Set the movement amount
-2147483648 to 2147483647
*5