Mitsubishi Electric MELSEC iQ-R CC-Link IE TSN, User Manual

Page: 239 / 330

4 TROUBLESHOOTING
4.7 Event List
237
4
Security
Operation
00C65 Time synchronization receive processing failure The receive processing for time synchronization failed.
00C70 CANopen initialization failure A communication error occurs in CANopen initialization processing.
00C71 Initialization failure (parameter mismatch between
master and slave stations) During initialization processing at the start of control communication, a parameter
mismatch was detected between the master station and slave stations.
00C72 Maximum response time mismatch during time-
managed polling A mismatch was detected in the maximum response time during time-managed polling.
Update the version of the engineering tool and the slave stations to the latest version,
and then retry the operation.
00C80 Slave station that does not support CC-Link IE TSN
Protocol version 2.0 detected A slave station that does not support CC-Link IE TSN Protocol version 2.0 was detected.
00C81 CC-Link IE TSN Class settings mismatch A mismatch was detected between the parameter of the master station and the CC-Link
IE TSN Class of the slave stations.
Event
code Overview Cause
10200 Remote password lock The lock processing of the remote password was performed.
10201 Remote password unlock successful The unlock processing of the remote password was succeeded.
10202 Remote password unlock failed The unlock processing of the remote password has failed.
10300 Access from IP restricted with IP filter setting Accessed from IP address restricted with the IP filter setting.
Event
code Overview Cause
24100 Own station: Parameter change/new parameter
reception Parameter was changed. Or new parameter was received at power-on.
24300 Own station: Enabling remote device test function Remote device test function was enabled.
24301 Own station: Failure in enabling remote device test
function (Programmable controller CPU is not in STOP
state (excluding a stop error)) The operating status of the programmable controller CPU is not in STOP state
(excluding a stop error), and enabling remote device test function failed.
24302 Own station: Failure in enabling remote device test
function (Own station is not set as a master station.) The own station is not set as a master station and enabling remote device test function
failed.
24303 Own station: Disabling remote device test function
(SB0016 is turned off.) Remote device test function was disabled because SB0016 (Remote device forced
output request) has been turned off.
24304 Own station: Disabling remote device test function
(Programmable controller CPU is in RUN or PAUSE
state). Remote device test function was disabled because operating status of the
programmable controller CPU has been changed to RUN or PAUSE state.
24305 Own station: Disabling remote device test function
(Programmable controller CPU indicates a stop error.) Remote device test function was disabled because a stop error has occurred in the
programmable controller CPU.
24307 Network number, station number, IP address setting/
change execution Setting or change of the network number, station number, or IP address of the own
station was executed.
24F00 Another station: CPU operating status change
detection Operating status of the CPU module on another station was changed.
Event
code Overview Cause