Mitsubishi Electric City Multi PURY-EM200YNW-A1, Service Handbook

Page: 249 / 503

[7-8 Error Code Definitions and Solutions: Codes [6000 - 6999] ]
76
- chapter 7 BS_07_M
7
Tro
ubles
hoot
in
g Us
in
g
Er
ror Codes
7-8-19 Error Code [6834]
1. Error code definition
MA remote controller signal reception error (Start bit detection error)
2. Error definition and error detection method

Communication between the MA remote controller and the indoor unit is not done properly.
 No proper data has been received for 2 minutes.
3. Cause
1) Contact failure of the remote controller lines of MA remote controller or the indoor unit.
2) All the remote controllers are set to SUB.
3) Failure to meet wiring regulations
 Wire length
 Wire size
 Number of remote controllers
 Number of indoor units
4) The remote controller is removed after the installation without turning the power source off.
5) Noise interference on the remote controller transmission lines
6) Faulty circuit that is on the indoor board and performs transmission/ reception of the signal from the remote controller
7) Problems with the circuit on the remote controller that sends or receives the signals from the remote controller
4. Check method and remedy
1) Check for disconnected or loose transmission lines for the indoor units or MA remote controllers.
2) Confirm that the power is supplied to the main power source and the remote controller line.
3) Confirm that MA remote controller's capacity limit is not exceeded.
4) Check the sub/main setting of the MA remote controllers.One of them must be set to MAIN.
5) Diagnose the remote controller (described in the remote controller installation manual).
[OK]: no problems with the remote controller (check the wiring regulations)
[NG]: Replace the MA remote controller.
[6832, 6833, ERC]: Due to noise interference <Go to 6)>
6) Check the transmission waveform, and check the MA remote controller line for electrical noise. For details, refer to the follow-
ing page(s). [8-4 Checking Transmission Waveform and for Electrical Noise Interference]
7) When no problems are found with items 1) through 6), replace the indoor unit board or the MA remote controller.
The following status can be confirmed on LED1 and 2 on the indoor unit board.

If LED1 is lit, the main power source of the indoor unit is turned on

If LED2 is lit, the MA remote controller line is being powered.
0000006452.BOOK 76 ページ ２０２１年１０月２７日 水曜日 午前９時３８分