METRODATA NetTESTER FAMILY USER MANUAL
76-02-107 Rev.A
Page 86 of 133
BANDWIDTH
use remote sla No
Cir 500M *
cBs 64k
Eir -
ebS -
bandwidth Utilisation
include s-tag Yes
include c-tag Yes
external tags 0
To revert a parameter to the value from the SLA definition, enter a value of zero.
14.2.6.1.3.2.1
Use Remote SLA
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters / S
L
A /
B
andwidth / Use
R
emote
SLA
SLA bandwidth parameters can be communicated from a L2 peer via the MDP
protocol and these may be used to override the local SLA values if required.
This feature is intended for the case of a point-to-multipoint configuration, where the
tester is connected to a high-speed trunk with one SLA, whilst the remote units have
a lower speed connection, with an SLA that reflects this.
14.2.6.1.3.3 Other Parameters
The remainder of the tester SLA menu shows the SLA parameters in the same
format as they appear within the Settings section.
The SLA definition cannot be altered from the tester menu.
14.2.6.2 Test Parameters (Basic Test)
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters
The appearance of the Test Parameters menu varies according to the Regime
selection. The Basic regime version is shown below:
TEST PARAMETERS
Regime Basic
traIning <menu>
SLA <menu>
Packet size/mix User
user-defined Size 1518
phase 1 rAte CIR
phase 1 Duration disabled
phase 2 raTe CIR
phase 2 dUration 2:00
stop on Fail Yes
dEtailed report No
14.2.6.2.1
Packet Size/Mix
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters /
P
acket size/mix
