METRODATA NetTESTER FAMILY USER MANUAL
76-02-107 Rev.A
Page 100 of 133
Viewing the report whilst a test is running will show the report as it is compiled, in
real-time. Once the test has ended, the completed report may be viewed.
14.2.6.12 Send Report
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester / S
E
nd Report
Once a report has been generated, it will normally be sent to the TFTP server
automatically. If, for any reason, the transfer failed, or must be repeated for any other
reason, this can be instigated manually using the Send Report command.
14.2.6.13 Store Settings
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester / St
O
re Settings
Changes made to the tester settings may be saved (along with all the other unit
settings) if desired.
14.2.7
SAM Tester (Tester Function, Multiple-Test Mode)
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester
The multiple-test mode allows up to 8 tests, which may have different regimes,
parameters and/or peers, to be defined and then automatically run in sequence. In
this mode, the SAM tester menu appears as shown below:
SAM TESTER
sam Function Tester
Multiple tests Sequential
Report settings <menu>
test Channels <menu>
14.2.7.1 Test Channels
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester / Test
C
hannels
The Test Channels item leads to a summary screen showing brief information about
the configured tests, their settings and status, as shown below:
TEST CHANNELS
-------------
Ch Name Peer Flow/Interface Regime State
-----------------------------------------------------------------------------
1 Test1 192.168.0.10 LAN1 Y.1564 Stopped
<Esc> - exit, 1.. - details, * - new, <Enter> - refresh
Existing tests may be accessed by pressing the key shown in the left-hand column.
A new test may be created by pressing '*'. In either case, this will lead to the test
channel settings menu, as shown below:
