METRODATA NetTESTER FAMILY USER MANUAL
76-02-107 Rev.A
Page 119 of 133
14.5.3.9 Send file to current settings
Menu Tree:
Main Set-Up / M
A
intenance /
C
onfig File / Send file to: C
U
rrent settings
The file can be used to set the current configuration of the unit.
Note that the content of the file replaces the running configuration of the unit, not the
saved settings. The new settings must be saved manually, if desired. Conversely,
until this is done, the configuration load may be 'undone' by restarting the unit.
If errors are detected in the configuration file, the first error will be reported, along
with the line number.
14.5.4
Software File functions
Menu Tree:
Main Set-Up / M
A
intenance / Soft
W
are File
The software file functions menu is shown below:
SOFTWARE UPGRADE
File name nt1005.943
contains Main 9.43.8
transfer status complete
programming not started
get file from:
Tftp server
use file to:
Program software <display>
Delete file
14.5.4.1 File name
Menu Tree:
Main Set-Up / M
A
intenance / Soft
W
are File /
F
ile Name
The name of the configuration file held on the unit is displayed, and can be changed
if desired.
14.5.4.2 File content
Menu Tree:
Main Set-Up / M
A
intenance / Soft
W
are File / Contains
The version number of the software contained within the file is displayed. If the file
contains boot as well as main software, both version numbers are shown.
14.5.4.3 Transfer status
Menu Tree:
Main Set-Up / M
A
intenance / Soft
W
are File / Transfer status
Whilst a software file is being transferred to the unit, the progress is displayed.
14.5.4.4 Programming status
Menu Tree:
Main Set-Up / M
A
intenance / Soft
W
are File / Programming
When the software file is programmed into the unit, the progress is displayed.
