METRODATA NetTESTER FAMILY USER MANUAL
76-02-107 Rev.A
Page 85 of 133
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters / Tra
I
ning /
R
ate
The training FPS (frames per second) defines the frame rate used during the training
period. The packet size will be the same as the main test (or the smallest, if there are
multiple sizes).
14.2.6.1.3
SLA
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters / S
L
A
SLA
sLa 1 "SLA1"
Bandwidth <menu>
flr 0.04%
ftd 100ms
ifdv 10ms
delay percentile 95
mtu 1518
14.2.6.1.3.1 SLA selection
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters / S
L
A / S
L
A
The SLA to test against can be selected from those that have been defined (see
sections 9, 14.1.5 and 14.1.6).
If RFC2544 regime is selected, an additional SLA selection option of
none
is
available. This corresponds to the normal, 'non-SLA', operating mode for RFC2544
testing. See section 10.3.1.2.5 for more details.
14.2.6.1.3.2 Bandwidth parameters
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters / S
L
A /
B
andwidth
The SLA bandwidth parameters are shown in the same format as they appear within
the Settings section, but the SLA definition cannot be altered from the tester menu.
It is, however, possible to override the values of any of the CIR, EIR, CBS and EBS
parameters. An override value will affect the operation of the test channel only. It will
not change the SLA definition, and it will not affect any other test channel that is
using the same SLA.
Parameters with overridden values are indicated on the menu with an asterisk (*).
