METRODATA NetTESTER FAMILY USER MANUAL
76-02-107 Rev.A
Page 84 of 133
TEST PARAMETERS
Regime Basic
traIning <menu>
SLA <menu>
Packet size/mix User
user-defined Size 1518
phase 1 rAte CIR
phase 1 Duration disabled
phase 2 raTe CIR
phase 2 dUration 2:00
stop on Fail Yes
dEtailed report No
14.2.6.1.1
SAM Test Regime
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters /
R
egime
The test regime selects how the traffic generator is to be controlled. The options are
as below:
Basic
The Basic mode allows for timed tests against the configured SLA
settings. See section 14.2.6.1.
RFC2544
RFC2544 Test mode enables a test mode to measure the throughput
and latency of the WAN port. See section 14.2.6.3.
Y.1564
Selects the Y.1564 test methodology. See section 14.2.6.4.
14.2.6.1.2
Training
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters / Tra
I
ning
In order to ensure that all forwarding tables and VPLS forwarding databases are
configured and the link is active prior to running the test, a training period can be
specified, where test packets are generated but not verified to ensure the connection
is activated.
TRAINING
Training Enabled
Period 10s
Rate 1000fps
14.2.6.1.2.1 Training Enable
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters / Tra
I
ning /
T
raining
The training period can be disabled completely if not required.
14.2.6.1.2.2 Period
Menu Tree: Main Set-Up /
T
esting /
S
AM Tester /
T
est Parameters / Tra
I
ning /
P
eriod
This setting defines the duration of the training period in seconds.
14.2.6.1.2.3 Rate
