METRODATA NetTESTER FAMILY USER MANUAL
76-02-107 Rev.A
Page 73 of 133
DHCP is always enabled when ZTC is used.
14.1.9.3 IP Address
Menu Tree: Main Set-Up /
S
ettings /
M
gmt Interface /
I
P Addr
In order to access the unit remotely it must be configured with an IP address. This
may be obtained either using DHCP, in which case this will be configured
automatically, or Manually if DHCP is disabled.
The IP address should be entered in the format AA.BB.CC.DD
By default, the aux port on LAN4 assumes the IP address 169.254.42.42 with DHCP
disabled.
14.1.9.4 Net Mask
Menu Tree: Main Set-Up /
S
ettings /
M
gmt Interface /
N
et Mask
The network mask is used to differentiate the network address from the host
address.
If DHCP is enabled, the net mask is served by the DHCP server and is configured
automatically.
14.1.9.5 IP Routing Table
Menu Tree: Main Set-Up /
S
ettings /
M
gmt Interface /
R
outing table
In order to operate within a routed network, and access hosts that are not located on
the same subnet, the routing table must be configured. The unit supports static
routing only.
The routing table menu is as shown below:
IP ROUTING TABLE
----------------
# Destination Mask Gateway Interface
-------------------------------------------------------------------------
1 0.0.0.0 0.0.0.0 10.1.1.254 MGMT
<Esc> - exit, 1.. - details, * - new, <Enter> - refresh
To edit a previously defined table entry, press the key shown in the left-hand column.
To create a new entry, press *. A typical table entry menu is shown below:
