1. Perform the following
SST
(Evaporative Emission System Tester 134-01049) self-test:
1. Verify the gas cylinder valve is closed and the control valve located on the tester is in the TEST
position. All tester display should be off at this time.
2. Connect the long hose (part of
SST
) to the tester.
3. Connect the manifold assembly (part of
SST
) to the long hose as shown in
Fig. 4
.
Fig. 4: Connecting Manifold Assembly To Long Hose
Courtesy of MAZDA MOTORS CORP.
4. Open the gas cylinder valve and verify the gas cylinder regulator left gauge reads
10 to 12 psi
(preset at factory).
If not, refer to the tester operators manual to contact tester manufacturer.
5. Press the ON/OFF switch to turn on the
SST
and make sure the left display reads
0.0
.
6. Turn the control valve on the tester to the FILL position.
7. Verify the left display reading is
within 13.9 to 14.0 in of water
.
If not, adjust the pressure using the regulator knob located on the right side of the tester.
8. Turn the control valve to TEST position and press the START switch.
NOTE:
If the tester does not work correctly during self-test, refer to the
tester operators manual for more detailed procedures.
2007 Mazda MX-5 Miata Sport
2007 ENGINE PERFORMANCE Emission System - MX-5 Miata
Microsoft
Thursday, July 09, 2009 2:38:03 PM
Page 3
© 2005 Mitchell Repair Information Company, LLC.
