Fig. 24: Identifying Key For Resistration
Courtesy of MAZDA MOTORS CORP.
1. Prepare two or more keys to be programmed after the key ID number clearing.
2. Connect the M-MDS to the DLC-2. (See
M-MDS CONNECTING PROCEDURE
.)
3. Using key 1, turn the ignition switch to the ON position.
4. Verify that the keyless warning light illuminates for
approx. 3 s
, and then goes out.
5. Select "BODY/SECURITY/PATS functions" from the menu.
6. Perform the security access according to the direction of the M-MDS screen. (See
SECURITY ACCESS
PROCEDURE[ADVANCED KEYLESS SYSTEM]
.)
7. Select "Parameter Reset" from the M-MDS screen menu.
8. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Exit (From
This Menu)" to finish the M-MDS procedure.
9. After Step 8, wait
5 s or more
, and then turn the ignition switch to the LOCK position.
10. Using key 1, turn the ignition switch to the ON position.
11. After verifying that the security light and keyless warning light illuminates
for 3 s or more
turn the
ignition switch to the LOCK position and remove key 1.
12. Using key 2, turn the ignition switch to the ON position.
13. Verify that the security light and keyless warning light illuminates
for approx. 3 s
, and then goes out.
14. After verifying that the security light goes out, turn the ignition switch to the LOCK position using key 2,
and then remove key 2.
15. If an additional key needs to be programmed, repeat Steps 13-14 with the additional key being key 3. If
the ignition switch is held in the ON position
for 1 min or more
, the additional key programming
procedure according to Steps 13-14 will not be possible. If this occurs, refer to "
NO.1 ADDITIONAL
KEY PROGRAMMING PROCEDURE (USING TWO VALID KEYS
)" to register any additional
keys.
16. Start the engine with the key 1.
17. Verify that the security light and keyless warning light operate as follows:
From the point when the ignition switch is turned to the ON position, the security light illuminates
for approx. 3 s
and goes out.
The keyless warning light illuminates with the ignition switch turned to the ON position, and after
approx. 1 s
after the engine is started, it goes out and displays the number of programmed keys.
NOTE:
Although the security light flashes and DTC 15 or 21 is displayed,
this does not indicate an improper procedure. Continue to perform
the procedure as indicated.
NOTE:
Although the security light flashes and DTC 21 is displayed, this does
not indicate an improper procedure. Continue to perform the
procedure as indicated.
2007 Mazda MX-5 Miata Sport
2007 ACCESSORIES & BODY, CAB Security and Locks (Advanced Keyless System) - MX-5 Miata
Microsoft
Thursday, July 09, 2009 3:36:54 PM
Page 21
© 2005 Mitchell Repair Information Company, LLC.
