Fig. 11: Removing Battery
Courtesy of MAZDA MOTORS CORP.
4. Put in the new battery (CR1620) with the positive pole (+) facing down.
5. Align the front and back covers and snap the transmitter shut.
Battery specification
Lithium CR1620 x 1
6. Install the key to the transmitter.
Fig. 12: Position Of Putting New Battery
Courtesy of MAZDA MOTORS CORP.
TRANSMITTER ID CODE REGISTRATION[KEYLESS ENTRY SYSTEM]
NOTE:
The batteries will last about 2 years when used 10 times a day.
CAUTION:
Always program three ID codes because the programming mode
terminates if three ID codes are programmed. At this time, the same
transmitter (programmed transmitter) can be programmed two or
three times.
NOTE:
Always program three ID codes because all the ID codes programmed
prior to activation are cleared when the programming mode is activated.
A maximum of three ID codes can be programmed.
When programming the ID code into a keyless control module, verify that
other transmitters are not being operated in the vicinity.
After ID code programming, remove the key from the steering lock and
verify that all doors lock/unlock normally using the transmitter.
2007 Mazda MX-5 Miata Sport
2007 ACCESSORIES & BODY, CAB Security and Locks (Keyless Entry System) - MX-5 Miata
Microsoft
Thursday, July 09, 2009 3:35:24 PM
Page 15
© 2005 Mitchell Repair Information Company, LLC.
