8. Select "Parameter Reset" from the M-MDS screen menu.
9. Perform security access again as indicated on the M-MDS screen. (See
SECURITY ACCESS
PROCEDURE[ADVANCED KEYLESS SYSTEM]
.)
10. Select the replaced part as indicated on the M-MDS screen.
When replacing only the PCM: Select "PCM".
When replacing only the instrument cluster: Select "HEC".
When replacing only the keyless control module: Select "RKE".
11. Perform "Program Additional card key". (When replacing keyless control module) (See
CARD KEY ID
CODE REGISTRATION[ADVANCED KEYLESS SYSTEM]
.)
12. Perform "Steering Lock Unit Programming". (When steering lock unit) (See
STEERING LOCK UNIT
ID CODE REGISTRATION[ADVANCED KEYLESS SYSTEM]
.)
13. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Exit (From
This Menu)" to finish the M-MDS procedure.
14. After Step 13, wait
5 s or more
and then turn the ignition switch to the LOCK position.
15. Using key 1, turn the ignition switch to the ON position.
16. After verifying that the security light and keyless warning light illuminate
for 3 s or more,
turn the
ignition switch to the LOCK position and remove key 1.
17. Using key 2, turn the ignition switch to the ON position.
18. Verify that the security light and keyless warning light illuminate
for approx. 3 s,
and then goes out.
19. After verifying that the security light goes out, turn the ignition switch to the LOCK position using key 2,
and then remove key 2.
20. If additional keys need to be programmed, repeat Steps 13-14 with the additional key to be programmed
being key 3. If the ignition switch is held in the ON position
for 1 min or more
, additional key
programming according to Steps 18-19 will not be possible. If this occurs, refer to "
NO.1
ADDITIONAL KEY PROGRAMMING PROCEDURE (USING TWO VALID KEYS
)" to program
CAUTION:
The M-MDS displays "At least two or more keys must be
programmed", however, do not perform the key programming
and proceed to Step 8. If the procedure is not followed, the
engine may not be started.
The key programming procedure is performed at Step 13-16.
NOTE:
At this time, do not select any other parts from the M-MDS screen
menu.
NOTE:
Although the security light flashes and DTC 21 is displayed, this does
not indicate an improper procedure. Continue to perform the
procedure as indicated.
2007 Mazda MX-5 Miata Sport
2007 ACCESSORIES & BODY, CAB Security and Locks (Advanced Keyless System) - MX-5 Miata
Microsoft
Thursday, July 09, 2009 3:36:54 PM
Page 25
© 2005 Mitchell Repair Information Company, LLC.
