Your local telephone company may make changes in its facilities,
equipment, operations, or procedures that affect the proper
functioning of this equipment. If they do, you will be notified in
advance to give you an opportunity to maintain uninterrupted
telephone service.
Hearing Aid Compatibility:
All system phones are compatible with
inductively coupled hearing aids as prescribed by the FCC.
IC Notification and
Repair Information
The Industry Canada (IC) label identifies certified equipment. This certification
means that the equipment meets certain telecommunications network protective,
operational, and safety requirements. The IC does not guarantee the equipment
will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that is permissible to
connect it to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the company’s inside wiring for single-line individual service may
be extended by means of a certified connector assembly (telephone extension
cord). The customer should be aware that compliance with the above conditions
may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made
by the user to this equipment, or any equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines, and internal metallic water pipe
system, if present, are connected. This precaution may be particularly important
in rural areas.
CAUTION:
Users should not attempt to make such connections themselves, but
should contact the appropriate electrical inspection authority or
electrician, as appropriate.
To prevent overloading, the Load Number (LN) assigned to each terminal device
denotes the percentage of the total load to be connected to a telephone loop
used by the device. The termination on a loop may consist of any combination of
devices subject only to the requirement that the total of the Load Numbers of all
the devices does not exceed 100.
IC Certification No:
See the label on the side of the control unit.
CSA Certification No: LR 60486
Load No: 7
!
FCC and IC Information
C-3
Summary of Contents for PARTNER Advanced Communications System Release 1.0
Page 6: ...iv...
