Programming
(See Figure 2-3 in Chapter 2 for the location of special programming buttons
such as
s
and
e
on system phones.)
To program an Outgoing Call Restriction button at extension 10:
1.
Press
f
0
0
s
s
#
1
1
4
at extension 10
or 11.
2.
At this point:
If you want to assign Outgoing Call Restriction to the first available
button, press
D
until a display similar to the following appears:
Outgoing CallRstr Button
1 Assigned - Ext10
If you want to remove the Outgoing Call Restriction button assignment,
press
D
until a display similar to the following appears:
Outgoing CallRstr Button
2 Not Assigned
If you want to assign Outgoing Call Restriction to a specific button,
press
3
. A display similar to the following appears:
Outgoing CallRstr Button
3 Select a Button
Then press a programmable button with lights to assign Outgoing Call
Restriction to that button.
3.
Select another procedure or exit programming mode.
4.
Label the Outgoing Call Restriction button at extension 10.
Using
To change an extension’s Outgoing Call Restriction setting:
1.
Press the Outgoing Call Restriction button at extension 10.
The green light next to the Outgoing Call Restriction button turns on and
extension 10 appears busy to the system.
2.
Press the Auto Dial button for the desired extension repeatedly until its lights
show the correct setting as follows:
No Restriction.
The green light next to the Auto Dial button is on
steady.
Inside Only.
The red light next to the Auto Dial button is on steady.
Local Only.
The green light next to the Auto Dial button flashes.
3.
Press the Outgoing Call Restriction button at extension 10 or lift the handset
and replace it back in the cradle.
The green light next to the Outgoing Call Restriction button goes off and
extension 10 resumes normal operation.
5-140
Outgoing Call Restriction Button (#114)
Summary of Contents for PARTNER Advanced Communications System Release 1.0
Page 6: ...iv...
