Problems with Manual Backup
Display Shows “Insert Valid Card” in
System Programming Mode
Possible Cause: The system did not detect a valid Backup/Restore PC Card when you
tried to do
a manual backup using
Backup Programming—Manual (#124)
.
What to do: Power down the system, insert a valid Backup/Restore PC Card in PC Card
Slot 2 of the PARTNER ACS processor module, and reapply power to the system. Restart
the procedure.
Display Shows “Card is Write Protected” in
System Programming Mode
Possible Cause: You tried to do a manual backup using
Backup Programming—Manual
(#124)
, but the Backup/Restore PC Card in the PC Card slot is write-protected.
What to do: Using the end of a paperclip or another pointed object, gently push the
write-protect tab upward to the nonprotected position (see Figure 6-7), and try the
procedure again. (You do not need to remove the card from the processor to slide the
write-protect tab up.)
Figure 6-7. Write-Protect Tab on a Backup/Restore PC Card
Display Shows “System Busy” in
System Programming Mode
Possible Cause: An automatic or manual backup was in progress at the time you
requested a manual backup.
What to do: Exit the procedure and retry the manual backup after a few minutes.
Slide the switch on the PC card
up to the nonprotected position
6-20
Troubleshooting
Summary of Contents for PARTNER Advanced Communications System Release 1.0
Page 6: ...iv...
