Valid Entries
1 = Assigned
2 = Not Assigned
✔
Programming
(See Figure 2-3 in Chapter 2 for the location of special programming buttons
such as
s
and
e
on system phones.)
To change the Voice Interrupt On Busy setting for an extension:
1.
Press
f
0
0
s
s
#
3
1
2
at extension 10
or 11.
2.
Enter the number of the extension to be programmed with this feature.
3.
To assign or unassign Voice Interrupt On Busy, press
D
until the
appropriate value displays.
4.
Select another procedure or exit programming mode.
Using
To initiate a voice interrupt on busy call:
1.
From a system phone, press
i
.
2.
Press
*
plus a two-digit extension number (or use an Auto Dial button).
3.
Listen for one of the following responses:
If you hear
one beep, you have reached an idle system phone. You
can speak after the beep.
Your voice is heard through the other extension’s speaker. If the
recipient is present, he or she can reply.
If you hear
two beeps, you have reached a busy system phone with
Voice Interrupt On Busy Assigned. You can speak after the beeps. Be
aware that the third party to whom the recipient is speaking probably
also will hear the two beeps and the faint sound of your voice.
If the recipient has a Voice Interrupt On Busy Talk-Back button, wait for
a response. If you hear a second set of beeps, the recipient has ended
the voice interrupt on busy call. In either case, hang up to end your part
of the voice interrupt on busy call.
If you
hear ringing, you have reached a standard phone, an idle MLC-6
or TransTalk 9000-series phone, or a system phone that is idle, has Do
Not Disturb turned off, and has Voice Interrupt On Busy Not Assigned.
Your call is not completed until someone answers.
5-194
Voice Interrupt On Busy (#312)
Summary of Contents for PARTNER Advanced Communications System Release 1.0
Page 6: ...iv...
