Possible Cause 2: The backup file is corrupted.
What to do: Retry the
Restore Programming (#125)
procedure.
If you get the same
result, try again
using a different backup file from the same Backup/Restore PC Card or a
file from a different Backup/Restore PC Card. Remember to power down the system
before you insert or remove Backup/Restore PC Cards.
System Programming Settings
Reverted to Default Settings
Possible Cause: You ran the
Restore Programming (#125)
procedure, but the restore
failed.
What to do: See Possible Causes 1 and 2 under “Display Shows ’Restore Failed-Try Again’
for Two Seconds in System Programming Mode."
Display Shows “Restore Complete,”
but All Calls Were Disconnected
Possible Cause: You just ran the
Restore Programming (#125)
procedure.
What to do: Nothing. This is normal behavior after a restore; the system resets itself. In
the future, warn users before beginning the restore, or perform the restore during
nonbusiness hours.
Troubleshooting
6-23
Summary of Contents for PARTNER Advanced Communications System Release 1.0
Page 6: ...iv...
