Rotary Dialing Timeout (#108)
Description
This System Programming procedure changes the length of the Rotary Dialing
Timeout. You may need to change the length of the timeout if you have any
rotary lines and you are having trouble calling out on standard touch-tone
phones. For example, if users dial slowly and calls are not completed or are
connected to wrong numbers, lengthen the timeout.
Related Features
Use this procedure only if the
for at least one outside line in
the system is set to rotary.
Considerations
Do not change this setting unless the system is experiencing problems.
Valid Entries
1 = 4 seconds
2 = 8 seconds
✔
3 = 12 seconds
Programming
(See Figure 2-3 in Chapter 2 for the location of special programming buttons
such as
s
and
e
on system phones.)
To change the length of the Rotary Dialing Timeout:
1.
Press
f
0
0
s
s
#
1
0
8
at extension 10
or 11.
2.
Press
D
until the appropriate value displays.
3.
Select another procedure or exit programming mode.
Rotary Dialing Timeout (#108)
5-153
Summary of Contents for PARTNER Advanced Communications System Release 1.0
Page 6: ...iv...
