Lucent Technologies 5ESS-2000, Operations And Maintenance Procedures, Page: 56 / 1421

Procedure 4.2: NONTELEPROCESSING WRITE OF AMA DATA FROM DISK TO TAPE
(FOR 9-TRACK)
OVERVIEW
NOTE 1: If office is optioned for ``teleprocessing'' mode, use
Procedure 4.16
.
NOTE 2: For specific information on the 5ESS
®
-2000 Switch Compact Digital Exchange (CDX), refer to
235-120-010, Compact Digital Exchange Reference Guide and 235-120-020, Compact Digital Exchange
User's Guide .
NOTE 3: For specific information on the 5ESS-2000 Switch Very Compact Digital Exchange (VCDX), refer to
235-120-110, Very Compact Digital Exchange Reference Guide and 235-120-120 , Very Compact Digital
Exchange User's Guide .
NOTE 4: If there is no DAT drive on MT 0 then 9-track tape writing for AMA is supported on both MT 0 and 1 for
medium density [1600 bits per inch (bpi)] tapes. Otherwise the 9-track is only supported on MT 1. Both
AMA streams ST1 and ST2 support either MT.
PROCEDURE
1. At the MCC, in order to obtain the current state of the AMA control file, type and enter:
OP:AMA:CONTROLFILE=a;
Where:
a
= ST1 used if AMA data goes to the ST1 data stream.
a
= ST2 used if AMA data goes to the ST2 data stream.
NOTE:
For a single-data-stream office , the stream does not have to be specified as either an ST1 or ST2;
however, for a dual-stream office , the stream must be specified as either an ST1 or ST2.
Response:
REPT AMA CONTROL FILE FOR STREAM a
OFFICE ID b
OFFICE TYPE c
DAYS UNTIL EXPIRATION d
PROCESS START TIME e
PROCESS STOP TIME f
DEFAULT MT FOR AUTO TAPE START g
h
i
AMAT PASSWORD j
HOC PASSWORD k
BACKUP HOC PASSWORD l
PASSWORD FROM LAST SESSION m
n
o
p
TAPE SEQUENCE NUMBER q
TAPE DATA SET ID r
Where: a = Data stream:
235-105-210 October 1999
Copyright © 1999 Page 1