Lucent Technologies 5ESS-2000, Operations And Maintenance Procedures

Page: 1195 / 1421

12. Correct any discrepancies and exit the view.
13. Diagnose the SAS memory unit, type and enter
DGN:SAS=
a-b,RAW,TLP;
Where:
a = SM number
b = SAS unit number
Response: DGN SAS=a-b COMPLETED ATP PH 1 - 5
Diagnostic is completed and all 5 phases are ATP.
14. Do not continue unless diagnostic is ATP phase 1 through 5. Resolve STF problem. Refer to
Table 14.19-1
.
15. To restore SAS memory unit to service type and enter,
RST:SAS= a-b;
Where:
a = SM number
b = SAS unit number
Response 1:
DGN SAS=a-b COMPLETED ATP PH 1 - 5
Diagnostic is completed and all 5 phases are ATP.
Response 2: MCC page 1090 identifies new SAS memory unit in service.
14.19.3.2 Backup Office Dependent Data
NOTE: Prior to the response, there will be completed responses for each SM/SM-2000, the AM, and the CMP if
applicable.
1. At the MCC, type and enter the following command:
BKUP:ODD,NRODD =
xx
,RODD,AM,CMP=0;
Where:
xx = SM number
Response: BKUP ODD COMPLETED
Note: Data base back up will take several minutes to complete.
2. Go to Section 14.19.4 .
14.19.3.3 Replace Flash Memory Card(s) In Existing Memory Board
WARNING 1:
An antistatic wrist strap must be worn while handling circuit packs to prevent damage to
components by static electricity.
WARNING 2: The programmed flash cards are factory set for Write Protect and should not be changed.
235-105-210 October 1999
Copyright © 1999 Page 8