Lucent Technologies 5ESS-2000, Operations And Maintenance Procedures

Page: 1031 / 1421

11.57.4 Reassign Billing Partitions
1. To identify the billing partitions assigned to stream ST2, type and enter
OP:AMA:CONFIG,ST2;
Response: REPT AMA CONFIG FILE FOR STREAM ST2 NUMBER OF EQUIPPED PARTITIONS d
TOTAL NUMBER OF
AMA BLOCKS e f g h
Where:
d = Number of AMA partitions equipped for this stream.
e = Total number of AMA blocks for this stream.
f = AMA partition number.
g = AMA partition file name.
h = Number of AMA blocks in this partition.
2. To determine read/write partition (should be same partition) for stream ST2,
type and enter
OP:AMA:MAPS;
Response:
REPT AMA DISK MAPS FOR STREAM a
WRITE PARTITION b READ PARTITION c
PARTITION d DISK MAP:
FPO: e LPO: f FPS: g LPS:
3. Prohibit the ST2 configuration for AMA partition, type and enter the following for some partition other than the
read/write partition for stream ST2:
SET:AMA:CONFIG:ST2,PART=
x
,UNEQUIP;
Where:
x = partition number (other than read/write partition).
Response:
REPT AMA CONFIG FILE FOR STREAM ST2 NUMBER OF EQUIPPED PARTITIONS d
TOTAL NUMBER OF
AMA BLOCKS e [ f g h ]
4. Repeat Step 3 for all partitions other than the read/write partition for stream ST2.
5. Unequip the read/write partition for stream ST2, type and enter
SET:AMA:CONFIG:ST2,PART=
x
,UNEQUIP;
Where:
x = read/write partition number.
6. After all partitions have been unequipped, make backup tapes to prevent loss of the updated AMA
configuration files in the event of a reload from tape.
7. Reconfigure billing partitions (recorded in Step 1) for stream ST1, type and enter
SET:AMA:CONFIG:ST1,PART=
x
,EQUIP;
235-105-210 October 1999
Copyright © 1999 Page 3