152
Bias = -25%, terminal A1 is used as frequency command input
When inputting a 0 V signal, the frequency command will be -25%.
When E3-00=0 and inputting a signal between 0 to 2 V, the frequency command will be 0%.
When E3-00=0 and inputting a signal between 2 to 10 V, the frequency command will be
between 0 to 100%.
When E3-00=1 and inputting 0 to 2 V, the motor will run in the reverse direction.
Gain = 100%
Frequency
command
0 V
2.0 V
10 V
Bias = -25%
E3-00 = 0
E3-00 = 1
E3-00 = 0
E3-00 = 1
2.0 V
10 V
-6 V
-10 V
Gain = 100%
Gain = -100%
d1-02
Gain = -150%
Figure 6.63 Frequency Command Adjusted by Input Gain and Negative Bias
E3-04
Retain
E3-05
Terminal A1 Input Filter Time
Sets the terminal A1 primary delay filter time, which can stabilize the drive operation by
eliminating the interference. Long filter time stabilizes the drive but causes slow response to
the analog input signal changes.
No.
Name
Setting Range
Default
E3-05
Terminal A1 Input Filter Time
0.00 to 2.00 s
0.5 s
E3-06
Terminal A2 Signal Level Selection
Selects the signal level for terminal A2. Refer to Table 6.21 on page 166..
No.
Name
Setting Range
Default
E3-06
Terminal A2 Signal Level Selection
0 to 3
1
0 : 0 to 20 mA
1 : 4 to 20 mA
2 : 0 to 10 V
Summary of Contents for EVO 6800 Series
Page 1: ...MANUAL Compact Vector Drive EVO 6800 Series...
Page 33: ...33 34 2 36 0 2 8 93 0...
Page 35: ...35 4 2 Main Circuit...
Page 41: ...41 4 3 Control Circuit...
