67
1 : Disabled
Automatically saves the most recently edited parameters started from A2-16 to A2-31
(maximum 16 parameters). When the edited parameters are more than 16, only the most
recent 16 parameters will be saved while the old ones will be removed.
6.2 Group b, Application
b1: Operation Mode Selection
b1- 00 Frequency Command Selection 1
Selects the frequency command source for the REMOTE mode.
Note:
When the run command is input with 0 Hz frequency command or below the minimum frequency, the RUN
LED will blink.
Press
to switch the frequency command source to LOCAL even if b1-00 is not set to 0 (Keypad).
No.
Name
Setting Range
Default
b1-00
Frequency Command Selection 1
0 to 4
1
0 : Keypad
Allows two ways to input the frequency command.
Switching between the multi-step speed command in parameters L1-□□.
(With multi-function inputs of control circuit terminals )
Entering the frequency command on the keypad.
1 : Control Circuit Terminal (Analog Input)
Allows a voltage or current input as analog frequency command from terminal A1 and A2.
□ Voltage Input
Allows a voltage signal input via terminals A1 and A2. Refer to Table 6.4 for parameter
settings.
Table 6.4 Frequency Command Using Voltage Signals
Terminal
Signal
Level
Parameter Settings
Notes
Signal Level
Selection
Function Selection
Gain
Bias
Summary of Contents for EVO 6800 Series
Page 1: ...MANUAL Compact Vector Drive EVO 6800 Series...
Page 33: ...33 34 2 36 0 2 8 93 0...
Page 35: ...35 4 2 Main Circuit...
Page 41: ...41 4 3 Control Circuit...
