Konica Minolta CS-7, Operation Manual

Page: 393 / 424

393
10 .2 Error codes and countermeasures
Chapter 10
Error code Displayed message Problems/countermeasures
F0I06*
F0I07*
[DR Detector name] capacitor error
If the panel after rebooting does not recover, contact a
service representative .
(1) Restart the DR Detector .
(2) Contact Konica Minolta technical representatives .
F0I08*
F0I09*
F0I10*
[DR Detector name] capacitor error
Can continue to use the panel . But, if the panel after
rebooting does not recover, contact a service repre-
sentative .
Lithium ion capacitor is degraded, or the power
consumption of the whole AeroDR SYSTEM has in-
creased .
(1) Restart the DR Detector .
(2) Contact Konica Minolta technical representatives .
However, continued use is possible .
F0I11*
F0I12*
F0I13*
[DR Detector name] capacitor error
If the panel after rebooting does not recover, contact a
service representative .
(1) Restart the DR Detector .
(2) Contact Konica Minolta technical representatives .
F0I14*
[DR Detector name] power source error
If the panel after rebooting does not recover, contact a
service representative .
F0I15*
[DR Detector name] capacitor error
If the panel after rebooting does not recover, contact a
service representative .
F0I16*
[DR Detector name] power source error
If the panel after rebooting does not recover, contact a
service representative .
F0I17*
AeroDR Battery Charger error
If the panel after rebooting does not recover, contact a
service representative .
F0I18*
[DR Detector name] Power source error
If the panel after rebooting does not recover, contact a
service representative .
(1) Restart the DR Detector and AeroDR Battery Char-
ger/AeroDR Battery Charger2 .
(2) Contact Konica Minolta technical representatives .
F0I19*
[DR Detector name] power source error
If the panel after rebooting does not recover, contact a
service representative .
(1) Restart the DR Detector .
(2) Contact Konica Minolta technical representatives .
F0I20*
[DR Detector name] power source error
Remove cable or cradle from the panel .
If the panel does not recover after a while, contact a
service representative .
(1) Remove the DR Detector from the AeroDR Battery
Charger/AeroDR Battery Charger2 or the wired
connection cable .
(2) Contact Konica Minolta technical representatives .
F0I21*
[DR Detector name] capacitor error
Contact a service representative .
(1) Restart the DR Detector .
(2) Contact Konica Minolta technical representatives .
F0I22*
[DR Detector name] power source error
If the panel after rebooting does not recover, contact a
service representative .
F0I23*
[DR Detector name] power source error
The AeroDR panel cannot be charging because of high
temperature inside the panel .
You can charge it again after cooling down .
(1) Move the DR Detector away from an electrical
carpet, a location exposed to direct sunlight, or a
place where heat can build up, then wait until the
temperature falls .
If an error occurs, charging will not be possible .
However, it will be possible to carry out exposures.
(2) If the problem persists, contact Konica Minolta tech-
nical representatives .
F0I24*
F0I25*
[DR Detector name] capacitor error
If the panel after rebooting does not recover, contact a
service representative .
(1) Restart the DR Detector .
(2) Contact Konica Minolta technical representatives .
F0I26*
[DR Detector name] internal error
If the panel after rebooting does not recover, contact a
service representative .
F0I27*
[DR Detector name] capacitor error
If the panel after rebooting does not recover, contact a
service representative .
F0I28*
AeroDR Battery Charger error
If the cradle after rebooting does not recover, contact a
service representative .
(1) Restart the AeroDR Battery Charger/AeroDR Bat-
tery Charger2 .
(2) Contact Konica Minolta technical representatives .
Continued on the next page