Konica Minolta CS-7, Operation Manual

Page: 264 / 424

264
7.7 One Shot stitching exposure
2
Press [Perform] .
• The exposure screen is displayed.
3
Load 2 or more detectors of the DR detec -
tor into the stitching holder .
• "Preparing" will be displayed in the work area
until exposure preparation and loading the DR
detector in a stitching holder is complete .
• When the exposure preparation of the DR detec -
tor loaded into the stitching holder is complete,
the work area detector status will be lit blue, and
"Ready" will be displayed .
IMPORTANT •••••••••••••••••••••••••••••••••••••
• When the DR detector with power off has been loaded
on the front side, since the overlapping portion may not
be able to be corrected, please make sure to turn on
the power of the DR detector loaded into the stitching
holder .
• When carrying out table position exposure in 2 DR de -
tectors, the dummy detector is loaded in the upper slot .
In addition, please make sure to always load this in the
upper slot since reflection of the dummy detector will
occur .
• One Shot stitching exposure outputs the merged im -
ages by correcting the overlapping portions of the cap-
tured image in the DR detector. Through the exposure
conditions, since lowering of the horizontal streaks
and contrast in the correction area may occur, please
carry out exposure so the diagnostic site does not
overlap the correction area .
• Please confirm whether the size of the DR detector
loaded in the stitching holder fits or not.
• Before exposure, always confirm the position and
number of DR detectors loaded in the stitching holder
in the exposure screen.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
4
Exposure .
• Set up the X-ray device before exposure.
Perform exposure after checking the exposure
settings .
Press the exposure switch