Konica Minolta CS-7, Operation Manual

Page: 376 / 424

376
9 .1 Various problems and countermeasures
When the followings occur while using this device, take
the respective countermeasures .
9 .1 .1 JM issues
When the backup JM is used in combination, it is pos-
sible to switch to the backup JM when a fault occurs
on the standard JM . Switch over must be performed
because when the JM has a fault, exposures are not
possible with the REGIUS .
Switching of the JM can be performed from this single
unit . At this time, it is unnecessary to restart this de-
vice, but the REGIUS must be restarted .
1
Press [System] .
• The system monitor screen is displayed .
• If the network status is not displayed, press the
[System Monitor] tab on the function switching
tabs .
2
Press [JM] .
• The JM status confirmation screen is displayed.
3
Select [Backup] .
• The confirmation screen is displayed.
4
Press [OK] .
• Press [Cancel], and the switchover of JM is can -
celled, returning to the JM status confirmation
screen, however, exposure cannot be performed
because a fault has occurred in the JM .
• The confirmation screen is displayed.
5
After checking that all REGIUS and this
unit have activated, press [OK] .
• Display returns to the JM status confirmation
screen .
• A confirmation screen indicating completion of
JM switchover and prompting restart of REGIUS
is displayed .
• Press [OK] to restart all REGIUS and the swi -
tchover of JM is completed .
• Exposure can be performed again.