Konica Minolta CS-7, Operation Manual

Page: 29 / 424

29
Chapter 1
1 .2 Safety precautions
CAUTION
Precautions when sending exposure setting
• When sending exposure setting to an external X-
ray device, check the exposure conditions on the X-
ray device. Be especially careful of X-ray exposure
settings when performing an exposure on a small
child .
Precautions when delivering an image from
this device to other devices
• Confirm that additional information such as set an -
notation is correct .
Precautions for exposure with the DR Detector
• Before exposure, confirm on the screen of this de -
vice that the DR Detector is registered in the expo -
sure room. Also, perform exposure after confirming
that the DR Detector to be used for exposure has
been selected .
• Do not leave the DR Detector in the vicinity of a
heating device such as a heated carpet etc .
Precaution on exposure dose
• After exposure, S values are displayed in the im -
age display areas of this device . Check that the S
values indicate the appropriate dosage for exposed
images .
Precautions when performing exposure in Aero
Sync mode
• Confirm that the device is ready for exposure
through its display before performing exposure.
• Confirm that a confirmation is sounded from the de -
vice after the start of exposure.
• Do not let the DR Detector vibrate or receive shock
until the preview image is displayed .
• Confirm that the DR Detector’s battery level is full
before performing exposure.
• Use within the range of the pre-checked exposure
conditions .
• Be aware that the exposure procedure must be
changed in some cases when the settings are
changed for the Aero Sync button or initial detection
level . Be sure to press the Aero Sync button after
changing the Aero Sync button setting from OFF to
ON .
• If the Aero Sync button or initial detection level has
not been set appropriately, a malfunction may occur
due to the DR Detector being subjected to impact .
Make sure values are changed appropriately .