Konica Minolta CS-7, Operation Manual

Page: 256 / 424

256
7.6 Auto stitching exposure with AeroDR Detector
7
Expose the second and third .
• Repeat from step 5 to perform exposure.
• Set up the X-ray device before exposure just
like for the first exposure. Perform exposure af -
ter checking the exposure settings.
• Exposed preview image is displayed.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• Preview images is first displayed on the exposure
screen . Because signal reception does not start until
all exposure is complete, it may take a while before
the image is displayed .
• If [Cancel] is pressed during a single examination, re-
exposure or additional exposure cannot be performed
for that examination.
• If you want to reject an image during exposure, press
[Cancel] followed by [
].
• You can perform reject even after all images have
been exposed. The target of reject is the image before
and after combination .
• Rejecting any image within a single examination
makes other images also the target for rejecting .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
7 .6 .3 Image combination
Images exposed by auto stitching using the DR Detec -
tor are combined automatically . The following proce-
dure describes an example of combining 3 images.
IMPORTANT •••••••••••••••••••••••••••••••••••••
• Automatic combination may fail depending on the con-
dition of the exposed image. Always check the com -
bination position visually, and adjust manually when
necessary .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
1
Select the images to be combined .
• Select images only if not already selected .
• Select the images to be combined from the or-
der list and press [ ] or [ ].
• The selected images are displayed in the com-
bined image display area .
• If you pressed [ ], continuously select the
associated images (second and third) .
HINT •••••••••••••••••••••••••••••••••••••
• [ ] and [ ] can be pressed only when the
Exam. Tag for stitching exposure is selected.
•••••••••••••••••••••••••••••••••••••••••••••••••••••
2
Press [Stitching] .
• The combination position confirmation screen is
displayed .