Konica Minolta CS-7, Operation Manual

Page: 222 / 424

222
7.3 Exposure with AeroDR Portable UF Unit
7 .3 .3 Exposure
Prepare for exposure using the AeroDR Portable UF
Unit according to the following procedure . The proce-
dure varies depending on the setting of the [AeroSync
Button] on the system monitor screen.
IMPORTANT
•••••••••••••••••••••••••••••••••••••
• Always check the patient information and exposure
conditions before exposure.
• Do not disconnect the Ethernet cable while the data is
being transmitted .
• The status of communication with the host is displayed
on the [System] button. For detail, refer to "7 .3 .1
Screen structure" .
• Available X-ray detection level varies depending on
the DR Detector model .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
HINT •••••••••••••••••••••••••••••••••••••
• This example shows a case in which the AeroDR 2
1417HQ or AeroDR 2 1417S is used .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
z
When the [AeroSync Button] is OFF
1
When you arrive at the exposure location,
turn on the power of the AeroDR Portable
UF Unit .
• Turn on the power switch of the AeroDR Por-
table UF Unit and confirm that the (green) power
LED is ON .
• For startup operation of the AeroDR Portable UF
Unit, refer to "AeroDR Portable UF Unit Opera-
tion Manual" .
• Confirm that the icon of the DR Detector to be
used in exposure is displayed on the application
bar .
IMPORTANT •••••••••••••••••••••••••••••••••••••
• When the AP information channel is set to [Auto CH],
press [Auto CH] on the system monitor screen (por
-
table) and check the channel .
• It may take several minutes for wireless connection to
start after turning on the AeroDR Portable UF Unit .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
2
Select the examination .
3
Press [Perform] .
• The exposure screen is displayed.
• A message "Ready" is displayed in the mes-
sage/button area, then the screen is locked .
• To change the X-ray detection level, press
[Pause] to enable modification. After changing
the detection level, press [Restart], then the
message "Ready" is displayed .
IMPORTANT •••••••••••••••••••••••••••••••••••••
• A malfunction may be caused by a shock to the DR
Detector. In such cases, set [AeroSync Button] to ON
on the system monitor screen .
• To prevent incorrect operations, always check that
"Ready" is displayed .
• Conditions for changing the detection level vary de-
pending on the X-ray device being used . If a survey
has been carried out when the system was installed,
follow the survey results .
• When using the AeroDR 3 1417HD, click the modal-
ity icon before making an exposure and select the
AeroDR 3 1417HD .
•••••••••••••••••••••••••••••••••••••••••••••••••••••