Konica Minolta CS-7, Operation Manual

Page: 92 / 424

92
5.2 Exposure procedure with DR Detector (Basic connection)
4
Take the 2nd image .
• Configure the X-ray device settings and check
the exposure setting before making an expo -
sure .
Press the exposure switch
(1)
(3)
(2)
• The exposed image is displayed in image display
area (2), and the focus moves to (3) . At this stage,
because the DR Detector is inserted in the wall
stand, exposure of (3) is not possible.
5
Remove the DR Detector from the wall
stand, and prepare for exposure with a
stand-alone DR Detector.
(1)
(3)
(2)
• When the DR Detector is removed from the wall
stand, "Preparing" is displayed in image display
area (3) .
6
Take 3rd image .
• Press the exposure switch after "Ready" is dis -
played in image display area (3) .
• Configure the X-ray device settings and check the
exposure setting before making an exposure.
Press the exposure switch
(1)
(3)
(2)
(1)
(3)
(2)
• The exposed image is displayed in image display
area (3) . The focus remains on image display area (3) .
IMPORTANT •••••••••••••••••••••••••••••••••••••
• When linked with the X-ray device, because the se-
lected exposure conditions at the time of X-ray expo -
sure are linked to the irradiation results, always check
the exposure conditions before X-ray exposure.
• Depending on the type of X-ray device, several sec-
onds may elapse before notification of the irradiation
results . For this type of model, take care because
sometimes irradiation results are not reflected correct -
ly if the exposure conditions are changed immediately
after X-ray irradiation .
•••••••••••••••••••••••••••••••••••••••••••••••••••••