5-2
A-61635 December 2010
Setting up patch
codes
Patch 2, 3, or T code
separation
The Patch 2, 3 or T separation settings under the Capture tab on the Job
Setup dialog box allow you to set up
Kodak
Capture Pro Software to recognize
patch codes as separators between batches or documents on your scanner.
Each patch has its separate window, but the commands are the same in all
three windows. You can set up the system to recognize all three patch codes
or just certain ones.
Detect Patch
— when checked, enables the
Detect Patch
option.
NOTES:
• If the
Detect Patch
check boxes are disabled in all three Patch Code
windows, the patch reader is disabled.
• If you have checked
Detect Patch
on any of the Separation by Patch dialog
boxes,
Kodak
Capture Pro Software checks each page for the type of patch
code you selected.
Alternatively search on 180° rotated images
— if patch code reading is
unsuccessful, this option rotates the image and searches for the patch code
again. This option helps prevents a patch code read failure because a page
was scanned upside down.
NOTE: The software always searches for patch codes in the first 4 inches
(10 cm) of the top of the image after rotation, deskew, and cropping (if
any). If a patch is vertical, the image should be rotated with the
Software rotation
option defined on the Page Setup dialog box.
Alternatively search on back
— if patch code reading is unsuccessful, this
option searches the back side of the document for the patch. If the software
detects a patch code on the front side, it will not look for a patch code on the
back side.
