Remote RMM-1400 Version 2.0x Configuration Guide
Getting Started: Setting Up the Initial Remote RMM-1400 Configuration
2-5
6. Configure the CLI session timeout as
20
minutes:
config timeout 20
7. Configure the host name as
Dub
:
config hostname Dub
8. Configure IP address
10.40.57.90
and subnet mask
255.255.0.0
:
config interface bridge switch ip address 10.40.57.90 255.255.0.0
Note:
The bridge switch interface forwards IP packets to the switched Ethernet
ports. You must assign an IP address to allow remote access to Remote
RMM-1400. This IP address is the primary Remote RMM-1400 IP
address.
9. Add a default route with gateway address
10.40.0.1
:
config ip route default 10.40.0.1
10. Configure the remote access protocol as
telnet-ftp
.
config remote-access telnet-ftp enable
Note:
Additional remote access protocols supported include SSH-SFTP, HTTP,
and HTTPS. Refer to the remote access configuration commands in the
Remote RMM-1400 Command Reference Guide
for more information.
11. (optional) Verify that the user environment has been set up properly:
running-config
The command response appears similar to the following:
(Dub)>running-config
# Product: Remote RMM-1400
# Version: 2.00
# Created: 2010-11-11,12:52:06.0,-05:00
# User: janedoe
# Bootloader Version: 1.00
config banner #
This is my banner.
\d
\t
#
config hostname Dub
config ip route default 10.40.0.1
config timeout 20
config users add janedoe supervisor -e$1$KwadE3g5$OzZeYQxk1CqLoyvm8/5pU. -e$1$Kw
adE3g5$OzZeYQxk1CqLoyvm8/5pU.
config interface bridge switch ip address 10.40.57.90/16
(Dub)>
Summary of Contents for RMM-1400
Page 14: ...TOC 6 Table of Contents ...
Page 242: ...Glossary 30 Glossary ...
Page 246: ...Copyrights 2 Copyrights and License Statements ...
