Kentrox RMM-1400, Configuration Manual

Page: 114 / 246

Remote RMM-1400 Version 2.0x Configuration Guide
Configuring Measurements and the Measurement Table: Overview
13-2
Overview
In addition to its central alarm table, Remote RMM-1400 provides a measurement
table that collects analog measurement values and reports these values to a central
management station, such as Optima. These measurement values can be sourced
from an analog input monitored by Remote RMM-1400, from a script running on
Remote RMM-1400 that monitors an attached network element, or via SNMP from a
network element that is monitored by SNMP proxy. The Remote RMM-1400
measurement table stores a 24-hour history of collected values.
Figure 13-1 Remote RMM-1400 Measurement Table
Each entry in the measurement table is identified by a name and contains an analog
value, units of measure (such as
V
,
%
,
deg C
, or
deg F
), the originator of the data
(such as
analog 1/1
or
script jobname_measurementname
), the NE name, an
optional description and category, and the maximum, minimum, and average
measured values over the reporting interval.
You can configure a measurement table entry such that the state of the measurement
will change based on the current value of the measurement. These states include:
 Loss-of-signal—The value has passed below the minimum measurable threshold
 Low—The value has passed below the minimum value that is considered normal